Saturday while at the shop, I managed to get the truck moved over a foot so I now have ample room around the back of the truck. I leveled it out as best as I could front to back as well as side to side. Then I proceeded to do a buncha math and over calculation to determine exactly how much material I had to chop out of the frame by the axle to bring things back down to flat again. I welded the outsides of the frame, then the inside, and started to blend the welds for overlays I plan on adding. I'm not exactly the most quick worker in the world with my level of OCD but I enjoy tweaking out on things. This week I hope to have the frame rails all done and blended, some crossmembers cut out that are blocking me, and the rear cab wall cut out so I can start throwing tubes at it. There is going to be a lot of stop and go with this truck as I'm having the platework laser cut so that will take some time but progress is progress!