Made a little gas filler neck piece for a buddy's C10 project. 18GA cold rolled and some silicon bronze. Also worked on the cage in the family truckster. I'm almost ready to drop it down so I can weld the top and put in the rest of the tubes.
Did some more work on the cage, welded up the bottom of everything then dropped the cage down to weld up the tops. Such a time consuming process, my out of position welding needs dome work too. Its getting closer, step by step.
Upgraded my cordless tool from some 15 year old DeWalt 18V stuff to the new Milwaukee Fuel. Holy shit these are nice. I have the Drill, 1/4" Hex impact, 1/2" drive mid torque impact, grinder and sawzall. I highly recommend these tools. I should have upgraded sooner.
I’ll post a picture tomorrow. The holes are pretty ugly from a combo butcher job courtesy of me and a drill, tin snips and a sawzall. It doesn’t matter though as they will be totally covered by flat plates on both sides.