ZFG SXS build

partybarge_pilot

Uno mas Cervesa!
May 14, 2004
9,759
556
113
Easton, KS
Well, what should have been a nice 3 hour flight home had turned into 3 flights and 16ish hours.

Fuck you winter.

Also fuck you Phoenix airport, pussies delay flights for a dusting of snow 20 miles away.

Fuck American airlines for not comping my drinks for sitting on the runway for over an hour.

Fuck that stewardess for not wanting me to use the first class head. Just threaten to whip it out right there and piss all over the first couple rows. She got out of the way but I got no more drinks. Bitch.

Putting the current bar tab on the company card. Will deal with that later.

Also fuck this fat snoring bitch next to me.
 

Attachments

partybarge_pilot

Uno mas Cervesa!
May 14, 2004
9,759
556
113
Easton, KS
Also, fuck you DFW and TSA for your double security check at the gate.

[Tinfoil hat on] some shit was going down in PHX, security everywhere [tinfoil hat off]

double fuck you to DFW for no bars being open at 4am. Inconsiderate fucks.
 

FasterNU

Mega Member
Jun 28, 2006
6,805
312
83
42
San Diego
clever idea on welding a nut to tube. That might be a good idea for me to steal on my new tie rods.

Rookie question here. I believe my tie rods might be normalized chromo??

If I did just a couple small tacks.... or say 2x tiny half inch welds. Would it ruin any heat treat or weaken the tube? Or, insignificant?
 

partybarge_pilot

Uno mas Cervesa!
May 14, 2004
9,759
556
113
Easton, KS
Silly bronze them if your worried about it.

Drilled 1-1/8" nuts for 1-1/4" tube. Some unplated shit I had laying around. They are not high quality fasteners, but they are perfect for this.
 

Latest posts

Today's birthdays

New Threads

New Classifieds

latest desert trips

Member Builds