Shifter Cable Routing and Grommets (Art Carr, Winters, Transfer Case)

Welcome to DezertRangers
Join the community. Register today for all the benefits of membership.
Register

smokeysevin

is Ron Burgundy?
Dec 28, 2012
437
112
43
Houston
The tundra is getting a winters/art carr shifter and a twin stick cable transfer case shifter. (https://www.dezertrangers.com/threads/another-toyota-on-a-ranger-site-this-i-have-to-see-01-tundra-boring-build.239166/page-2#post-3964958)

I picked up some firewall grommets from Jegs (https://www.jegs.com/i/Daystar/319/KU20040BK/10002/-1)

The cables are stock from winters for the transmission shifter
The transfer case shifter cables are 48" long 2" throw -4 cables from kartek.

Space is pretty tight under the floor and I have to work around the driveshaft, transfer case, exhaust, and floor.

I am thinking about cutting a piece of box steel at an angle and running the grommets up at an angle by welding the box to the floor.

Do any of y'all have experience/input on how to do this properly?

Sean
 

FasterNU

Mega Member
Jun 28, 2006
7,415
796
113
San Diego
i'm getting sad realizing that after all this time plugging holes in G4 cab... I'm gonna have to put some big ass ones right back in it. LOL
 
  • Like
Reactions: smokeysevin

smokeysevin

is Ron Burgundy?
Dec 28, 2012
437
112
43
Houston
I used the seymor buttz steelit knockoff over some seam sealer. Hopefully it seals up well enough. I was out of my thinner mig wire so its welded enough for structure but not full gnar sibr like yall do.

Sean

Sent from my LM-G710 using Tapatalk
 

Latest posts

New Threads

New Classifieds

latest desert trips

Member Builds